Arlington LV1-1CS Single Gang Low Voltage Mounting Bracket Device

Product Details

Item Weight: 1.6 ounces
Shipping Weight: 1.6 ounces (View shipping rates and policies)
Shipping: This item is also available for shipping to select countries outside the U.S.
ASIN: B000UEAJWU
Item model number: LV1-1CS

By : Arlington Industries
Price : $3.36

Item Description

From the Manufacturer
Arlington LV1-1CS Single Gang Low Voltage Device. Arlington's non-metallic, LV1-1CS, Low Voltage Mounting Brackets are the time and capital-saving solution for more rapidly and easier mounting of Class 2 communications, computer and cable Tv wiring. The bracket is its own template. Level the bracket on the wall. Then use the bracket a s a guide for the cut out by tracing a line around the inside. Arlington fittings are cautiously inspected and our manufacturing process is created to prevent the possibility of a defective item leaving our plant. In the event any of our merchandise are found to be defective, we will replace them with new product free of charge. The time limit for this warranty is one particular year following the date of sale or one year following the date of installation, whichever is the earlier date. This warranty does not apply when the product is used for any objective other than the intended use as described in the Arlington literature. This warranty does not apply when the product is applied for any installation which would violate the national electrical code or any code which takes precedence in a certain jurisdiction. Labor is not included.
- Single Gang - Mount low voltage Class 2 wiring devices to current walls, 1/4 Inch to 1 Inch Thick. - One-piece, nonmetallic, nonconductive construction. - Mounts vertically or horizontally - For installing telephone jacks, coaxial cable, cable Tv-other handy use tool! - Color: Black

Technical Details

Single through 4-gang brackets for installations on existing construction
Adjusts to fit 1/4" to 1" thick wallboard, paneling or drywall
For communications, cable TV, computer wiring
UL/CSA listed
Mounting wings hold bracket securely against wall when screws are tightened

Customer Reviews

I wanted to run my home theater cabling inside the walls and over the ceiling, which required some type of finished terminals for the speaker ends. This bracket was ideal to cut into the various locations in the ceiling and walls, then add a single gang plate for the jacks, thus allowing me with a short run from the speakers using banana plugs. There isn't much need for a single gang box since the entire installation is low voltage. Anyone possessing rudimentary carpentry skills should be able to do the job fairly readily. I recommend that you cut the holes just a little undersized, then trim to fit taking care to ensure that the tops and bottoms are parallel and square with the two sides of each bracket. It helps to be certain that the holes are well marked before making the cuts with a good drywall saw so as to avoid oddly shaped holes and out of plumb work. Of course, you can patch it up afterward, however that takes time. I might mention that I looked at mounting brackets at my local hardware/lumber mass merchandiser when I did the installation and found their solutions to be about 4 times the cost and inferior in quality and utility. (They just happen to have orange as one of their corporate colors.) It did take a few days for UPS ground to deliver, however it takes a while to do all the prep work and get the cable runs in place anyway, so you'll likely be just about ready for them when they arrive. Good product and the seller was responsive.

It does what it was designed to do. I didn't have any problem installing it, or attaching the "Recessed Low Voltage Cable Plate by DataComm Electronics"